2 / 2
THERMAL MANAGEMENT SOLUTIONS
EN-DigiTraceE104E304E307-IM-H58783 01/13
© 2011-2013 Pentair.
PN 601607-000
NORTH AMERICA
Tel: +1.800.545.6258
Fax: +1.800.527.5703
Tel: +1.650.216.1526
Fax: +1.650.474.7711
EuROpE, MIddlE EAsT, AfRICA
Tel: +32.16.213.511
Fax: +32.16.213.603
AsIA pACIfIC
Tel: +86.21.2412.1688
Fax: +86.21.5426.2917
lATIN AMERICA
Tel: +55.11.2588.1400
Fax: +55.11.2588.1410
Pentair and DigiTrace are owned by Pentair or its global affiliates. All other trademarks are the property of their respective owners. Pentair reserves the
right to change specifications without prior notice.
WWW.THERMAl.pENTAIR.COM
Installing the Contactor
1. Verify that the contactor is suitable for the area where it is to be
installed.
2. Check the line voltage and the heat-tracing load to ensure that
the contactor ratings are not exceeded.
3. Mount the enclosure in a position that prevents condensation from
draining into the enclosure from the connecting conduit
(see diagram at right).
Conduit
drain
Wiring
Figure 1.
Contactor control for switching heat-tracing loads greater
than 22 A or switching multiple heat-tracing circuits.
Control
thermostat
C
C
NO
NC
NO
NC
Ø
C
G
G
C
N
A
N
B
N
C
Ø
B
Ø
A
Ø
2C
Ø
1A
Ø
1B
Ø
1C
Ø
2B
Ø
2A
120-V
or
208/240-V
or
277-V
coil
Braid
208/240-V supply – 240-V heater or
120-V supply – 120-V heater or
277-V supply – 240-V heater
GFEPD
Heating
cable C
Heating
cable B
Heating
cable A
Figure 2.
Contactor control for switching heating cable On/Off.
Control
thermostat
T-stat & coil supply
120-V or 277-V supply
480-V & 600-V heater
Control voltage
C
C
NO
NC
NO
NC
Ø
C
G
C
N
Ø
B
Ø
A
G
N/Ø
Ø
Coil to
match
control
voltage
To heating cable
GFEPD
GFEPD
