Ra
yClic
®
F M
APP
ROV
ED
with HW
AT, IceSto
p,
and XL-T
race heati
ng
cables.
CL I, Div
. 2,
Gr. A,B,C,D
Hazardous Locations
with GM-XT only
.
WARNING:
Do not open while ener
giz
ed
Shoc
k Hazar
d
718K Pipe Heating Cable
also Listed De-icing and
Snow
Melting Equipment
-W
DESCRIPTION
The nVent RAYCHEM RayClic-LE Lighted End Seal Kit is for use
with nVent RAYCHEM IceStop, XL-Trace and HWAT heating
cables. The connection is designed to be installed above the
pipe insulation or mounted on the wall at the end of the heating
cable circuit. These installation instructions should be used
in conjunction with the IceStop, XL-Trace and HWAT System
Installation and Operation Manuals.
For technical support contact your nVent representative or call
nVent (800) 545‑6258.
TOOLS REQUIRED
• Utility knife
• Wire cutters
• TORX
®
T20 screw driver
OPTIONAL ACCESSORIES (Not included in this kit):
• nVent RAYCHEM RayClic‑SB‑02 Wall mounting bracket
KIT CONTENTS
Item Qty Description
A
1
Lighted end seal
B
1
Pipe mounting bracket
C
2
Plastic cable ties
D 1 Clip
E
1
Cable lubricant
A
B
C
D
E
APPROVALS
718K Pipe Heating Cable
877Z De-Icing and Snow Melting
Not UL Listed with XL-Trace heating
cable for buried piping.
APPROVED
-w
For HWAT, IceStop, and XL-Trace only
Hazardous Locations: For IceStop (GM-XT) only
Class I, Div. 2, Groups A,B,C,D
RayClic Connection System
RayClic-LE Lighted End Seal Kit Installation Instructions
This component is an electrical device that must be
installed correctly to ensure proper operation and to
prevent shock or fire. Read these important warnings and
carefully follow all the installation instructions.
• To minimize the danger of fire from sustained electrical
arcing if the heating cable is damaged or improperly
installed, and to comply with the requirements of nVent,
agency certifications, and national electrical codes,
ground-fault equipment protection must be used. Arcing
may not be stopped by conventional circuit breakers.
• Bus wires will short if they contact each other. Keep bus
wires separated.
• Keep components and heating cable ends dry before
and during installation.
• The black heating cable core is conductive and can
short. It must be properly insulated and kept dry.
• Component approvals and performance are based
on the use of nVent-specified parts only. Do not use
substitute parts or vinyl electrical tape.
• Leave these instructions with end user for reference
and future use.
WARNING:
