Page 19 of 30
REC
Saving parameter signal
RST
Total reset signal
The board has been reset. The cause of this signal can be a either
prolonged absence of power or if the reset button has been pressed
manually. The module will save all the information recorded, with the
exception of clock setting.
RSE
Memory reset
The eeprom memory has been reset (see chapter 7.2). The module
returns to the factory settings
ESG
Memory reset
carried out
Confirms that the eeprom memory has been reset (see chapter 7.2).
FAL
End of alarm (in
memory)
Indicates the end of an alarm.
TOP
Maximum power
complementary
pump
The complementary pump is on at the maximum frequency possible.
ON
Complementary
pump on
The complementary pump is on and regulating.
STB
Complementary
pump on standby
The complementary pump is on standby.
6.3 ALARM TABLE
MESS
DISPLAY
DESCRIPTION ACTION
A01
No water alarm -
temporary
Error due to the temporary
absence of water. This occurs
when water is absent and the
restart mechanism has been
activated. The will wait before
restarting in order to attempt to
automatically reset the error.
Check the water level in the first
tank or the aqueduct pressure.
Wait for the programmed
attempted restart or press the
button START/STOP for a manual
restart.
A02
No water alarm -
definitive
This condition occurs when there
is no water and the automatic
restart system has not activated
or restart attempts occurred
already without managing to reset
the system functioning.
This alarm condition closes the J3
contact on the power board for
possible external signals (alarm
light, siren, etc.)
Check the water level in the first
tank or the aqueduct pressure.
Press the button START/STOP to
manually restart the system.
A03
Pressure
transducer alarm
This signal occurs when the
control board cannot identify the
transducer pressure signal.
Check the pressure transducer is
correctly connected.
If the error occurs again, contact
your nearest assistance centre.
19 - GB -
46
