LEGEND® II INSTALLATION MANUAL
D. Periodic Maintenance
The following parts are wear items that should be
checked, maintained or replaced as needed. Wear
items are considered any working or moving part(s)
being worn due to the use of the cleaner.
Wear items
are not covered under warranty.
1. Wall Fitting Screen
Inside the wall fitting is a filter screen that acts as a
secondary filter. This screen is to keep debris that is
passed by the pool filter out of the Legend
®
II.
Running the Cleaner without the filter screen can
damage the Legend
®
II and will void the warranty.
A continuous plugged or dirty screen is a sign of
problems in your pool filtration system and you need
to contact your local pool professional.
To clean the filter screen, pull the screen out from
inside the Wall Fitting and rinse thoroughly and push
back inside the wall fitting.
Whenever cleaning, back washing or repairing filter,
remove the wall fitting and flush out the dedicated
line before using the Legend
®
II.
7
C. Cleaning the Sand & Silt Bag
- (cont.)
Gently push on top of the "U" shaped snap lock
closure to make sure it snaps into place.
Your debris bag is ready to be reinstalled onto your
cleaner.
"U" SHAPED
SNAP LOCK
CLOSURE
CLIP
Push down to
snap together.
CLEANER BAG
OPEN
OPEN
If you have a lot of debris in your pool, especially
after a storm, you can run your Legend
®
II in two
shorter cycles per day and empty the debris bag
between cycles.
Reconnect the debris bag to the vacuum tube.
Do NOT over turn.
A Helpful Hint:
It is easier to empty the debris bag
when it is dry. A second bag may be used while the
full debris bag is drying.
It's best to empty the debris bag when it becomes
half full. The Legend
®
II will have better performance
if the bag is not overloaded.
Summary of Contents for Legend II
Page 23: ...Notes ...
