LEGEND® II INSTALLATION MANUAL
III. Operation/Periodic Maintenance
A. Connecting/Disconnecting the
Legend
®
II
Turn off pool pump. Then take the Wall Fitting and
twist lock the Wall Fitting clockwise into the Wall
Adapter. To disconnect the Legend
®
II, unlock and
twist counter clockwise. The Wall Adapter should
remain in the pool wall.
B. Turning On/Off the Legend
®
II
The Legend
®
II operates off a filtration pump coming
from the equipment pad, and can be turned on or off
by merely turning on/off your pump time clock.
C. Cleaning the Sand & Silt Bag
Carefully unlock the debris bag from the vacuum
tube. Use your thumb to push the "U" shaped snap
lock closure upward until it snaps open. Make sure
to swing it away from the opening. Open the bag and
remove debris.
3. Checking RPM - (cont.)
1. Clean the Screen located inside the Wall Fitting.
A small amount of debris will significantly affect
the performance of the cleaner.
2. Clean the skimmer basket, pump basket and pool
filter.
3. If an adjustable Gate (3-way) Valve has been
installed, adjust the valve to increase water flow
to the Legend
®
II.
4. If the RPM is more than 32, at the Wall Fitting,
unscrew the Pressure Relief Valve slowly until
the RPM falls between 25-32. Again, if an
adjustable gate (3-way) valve has been installed,
adjust the gate valve to decrease water flow to
the Legend
®
II.
5. If you continue to have problems with either the
water flow or obtaining the specified water
pressure to operate the Legend
®
II, call your
Professional Pool Dealer.
If you have any additional questions, please
contact Pentair Water Pool and Spa, Inc.,
Technical Support Department at:
1-800-831-7133, Monday through Friday.
6
Push middle of
the bag inward
for closure.
OPEN
CLOSE
CLEANER BAG
"U" SHAPED
SNAP LOCK
CLOSURE
OPE
N
OPE
N
To close, push the middle of bag inward, as shown,
and bring the edges together to make them stack like
an accordion. Swing the "U" shaped snap lock
closure back to the closing position.
Summary of Contents for Legend II
Page 23: ...Notes ...
