background image

STANDARD LIMITED WARRANTY

Pentair Hydromatic® warrants its products against defects in material and workmanship for a period of 12 months from the date of  
shipment from Pentair Hydromatic or 18 months from the manufacturing date, whichever occurs first – provided that such products are 
used in compliance with the requirements of the Pentair Hydromatic catalog and technical manuals for use in pumping raw sewage, 
municipal wastewater or similar, abrasive-free, noncorrosive liquids.

During the warranty period and subject to the conditions set forth, Pentair Hydromatic, at its discretion, will repair or replace to the  
original user, the parts that prove defective in materials and workmanship. Pentair Hydromatic reserves the right to change or improve 
its products or any portions thereof without being obligated to provide such a change or improvement for prior sold and/or shipped units.

Start-up reports and electrical schematics may be required to support warranty claims. Submit at the time of start up through the Pentair 
Hydromatic website: http://forms.pentairliterature.com/startupform/startupform.asp?type=h. Warranty is effective only if Pentair 
Hydromatic authorized control panels are used. All seal fail and heat sensing devices must be hooked up, functional and monitored or this 
warranty will be void. Pentair Hydromatic will cover only the lower seal and labor thereof for all dual seal pumps. Under no circumstance will 

Pentair Hydromatic be responsible for the cost of field labor, travel expenses, rented equipment, removal/reinstallation costs or freight 

expenses to and from the factory or an authorized Pentair Hydromatic service facility.

This limited warranty will not apply: (a) to defects or malfunctions resulting from failure to properly install, operate or maintain the unit in 
accordance with the printed instructions provided; (b) to failures resulting from abuse, accident or negligence; (c) to normal maintenance 
services and parts used in connection with such service; (d) to units that are not installed in accordance with applicable local codes, 
ordinances and good trade practices; (e) if the unit is moved from its original installation location; (f) if unit is used for purposes other than 
for what it is designed and manufactured; (g) to any unit that has been repaired or altered by anyone other than Pentair Hydromatic or an 

authorized Pentair Hydromatic service provider; (h) to any unit that has been repaired using non factory specified/ OEM parts.

Warranty Exclusions: PENTAIR HYDROMATIC MAKES NO EXPRESS OR IMPLIED WARRANTIES THAT EXTEND BEYOND THE DESCRIPTION ON 
THE FACE HEREOF. PENTAIR HYDROMATIC SPECIFICALLY DISCLAIMS THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS 
FOR ANY PARTICULAR PURPOSE.

Liability Limitation: IN NO EVENT SHALL PENTAIR HYDROMATIC BE LIABLE OR RESPONSIBLE FOR CONSEQUENTIAL, INCIDENTAL OR 
SPECIAL DAMAGES RESULTING FROM OR RELATED IN ANY MANNER TO ANY PENTAIR HYDROMATIC PRODUCT OR PARTS THEREOF. 
PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY RESULT FROM IMPROPER INSTALLATION. PENTAIR HYDROMATIC DISCLAIMS 
ALL LIABILITY, INCLUDING LIABILITY UNDER THIS WARRANTY, FOR IMPROPER INSTALLATION. PENTAIR HYDROMATIC RECOMMENDS 
INSTALLATION BY PROFESSIONALS.

Some states do not permit some or all of the above warranty limitations or the exclusion or limitation of incidental or consequential 
damages and therefore such limitations may not apply to you. No warranties or representations at any time made by any representatives of 
Pentair Hydromatic shall vary or expand the provision hereof.

HYDROMATIC

© 2018 Pentair plc. All Rights Reserved. 

Warranty Rev. (07/09/18)

1101 Myers Parkway 

Ashland, OH 44805 
USA 
Ph: 855.274.8947

490 Pinebush Road 

Unit 4 

Cambridge, Ontario N1T 0A5
Canada
Ph: 800.363.7867

www.hydromatic.com

Summary of Contents for S3HRC













Reviews: