O P E R A T I O N
P E N N Y & G I L E S D R I V E S T E C H N O L G Y
Chapter 1:
18
Solo Technical Manual SK74484/1
If the battery gauge shows just red, either steady or flashing slowly,
then you should charge the batteries immediately.
11.0 Programming
If you find that you cannot find a position of the speed limiting
control that suits you, the controller can be programmed to meet
your needs.
The SP1 is a small hand-held unit which can be plugged into your
controller to alter the program. An SP1 may be included with your
vehicle. If an SP1 is not included, your vehicle distributor or service
agent or vehicle manufacturer will be able to program your
controller for you.
If you have an SP1, read the SP1 user guide before you use it.
If you re-program your controller, make sure that you observe any
restrictions given in your vehicle’s user manual. Note any changes
you make for future reference.
The SP1 programmer should not be connected to a Solo when the
vehicle batteries are being charged. The high voltages present
during charging may damage the SP1 programmer.
WARNING
Programming should only be conducted by competent
personnel with in-depth knowledge of Penny & Giles
electronic controllers. Incorrect programming could result in
an unsafe set-up of a vehicle for a user. Penny & Giles accept
no liability for losses of any kind if the programming of the
controller is altered from factory pre-set values.
12.0 Controller Servicing
All repairs and servicing must be carried out by authorized service
personnel. Opening or making any unauthorized adjustments or
modifications to the controller or its components will invalidate
any warranty and may result in hazards to yourself or other people,
and is strictly forbidden.
+