4
047657 r7
general InforMaTIon
1. Remove shipping straps and carton lid
from chair box. Remove the seat
cushion and seat rail from the box.
Finally remove the shipping container’s
outer sleeve.
2. Remove the four 3/8” bolts that secure
the chair’s base plate to the shipping
pallet. Remove any other packing or
straps that retain the chair to the
shipping pallet.
3. Carefully slide the chair from the pallet
to the location to be installed.
4. Check to see that the chair base is on a
level surface and that the chair does not
rock due to high or low spots on the floor.
If the surface is uneven, use the supplied
leveling pads found in the chair hardware
kit to eliminate gaps between the floor
and the chair base.
afTer THe CHaIr Is PosITIoneD anD
leVeleD,
REMOVE THE CLEVIS PIN AND
LOCK PIN. REMOVE THE PLUG THAT IS
LOCATED IN THE CENTER HOLE OF THE
LOCKING PLATE.
5. Locate the box containing the headrest.
Lower the headrest glide bar into the
headrest guides as shown in figure 1.
Position backrest cushion so that cushion
keyholes are seated onto backrest pins.
Standing directly behind the backrest
structure, use both hands and apply
downward pressure in a jogging motion
until the cushion is installed (see figure 1).
WarnIng:
Chair weight is in
excess of 250 pounds. Use
an assistant to safety position
the chair.
Headrest
Guide
Backrest
Pins
Backrest
Structure
Headrest
Keyhole
Slot
Backrest
Cushion
REMOVE
COVER
REMOVE
COVER
CLEVIS PEN
LOCK PIN
PLUG
Figure 1
Summary of Contents for Spirit 3000 Series
