Can
adian Comfort Industries V04
22
PELPRO OWNERS MANUAL
Copyright 2004
www.pelprostoves.com
Dansons Group Inc.
O
PERATING
Y
OUR
S
TOVE
The operations and maintenance of your PELPRO stove are unique
and should not be considered to be like a
wood, coal stove, gas, electric, propane or oil heater.
Cautions
:
Do not try to operate your stove with viewing or ash pan doors open. Pellets will not feed under these
circumstances and a safety concern may arise from sparks or fumes entering room.
Burn only pellet fuel that complies with PFI standards. Burning other types of fuels may result in the
formation and leakage of Carbon Monoxide which if undetected can be deadly.
If you are not drawing combustion air from outside, care must be taken to allow for adequate air
make up, to avoid possible room air starvation when stove or other exhaust fans are in operation.
It is recommended that you install a high quality smoke detector in the room where stove is installed.
Care should be taken to make sure detector is in working order at all times.
HOW YOUR
PELPRO
STOVE WORKS
Fuel in the form of wood pellets is stored in the hopper. An auger delivers the pellets to the burn grate. The fuel
rate, or heat output, is set by adjusting the feed rate touch pad, (settings 1 to 4). A fan provides combustion air to
the burn grate. The amount of combustion air in the burn grate is adjustable and automatically changes as the fuel
rate changes. The higher the fuel rate, the larger the amount of combustion air and visa versa. The fuel burns in
the burn grate, producing heat. Some heat radiates out the front of your stove. The majority of the heat passes
around the heat exchange tubes and air plenum around the firebox and is then moved into the room by the room air
fan. A small amount of heat must pass out of your stove, along with exhaust gases, into the atmosphere.
Your stove's heat output can be adjusted from setting 1-4,
through the FEED RATE touch
pad, to vary your heat output from
Low to High. The room air fan can
be manually adjusted through the
FAN SPEED to run faster or slower
to correspond to the amount of
heat being produced. The room air
fan is also on a limit switch,
controlled to run on high when the
stove reaches higher temperatures
and then resume the speed you
had selected once it cools to a
lower temperature.
Your stove can run efficiently over
extended periods of time and at
different heat output levels as long
as the fuel supply is uninterrupted and
timely cleaning and
maintenance is performed
. An example of how improper
cleaning effects operations is; the exhaust pressure switch
will shut the pellet supply off and your stove will shut off if
the exhaust system becomes plugged.
Figure 29
