21
FILL THE HOPPER WITH FUEL:
Open the hopper lid by placing your fingers in the recessed
handle on the hopper lid and lifting upward.
Lift the lid until the lid is fully open, toward the back of the
stove, and stays open by itself.
Ensure the hopper is clean of any debris, MANUALS, or
other foreign objects that could jam up the fuel feed auger.
You may wish to wipe clean any oils, or manufacturing
leftovers, using any cleaning agent and a cloth. As well
a light application of car wax to the hopper will aid in
reducing build-up of dust and fines within the hopper.l
Be careful not to spill any fuel on the top of the stove and
adjoining gaps. Spilling fuel on the floor can also pose a
slipping hazard.
CLOSE THE LID, place finger into the recessed handle and
With control, pull the lid toward the front of the stove.
CAUTION: WATCH YOUR FINGERS.
O
O
PERATING
PERATING
I
I
NSTRUCTIONS
NSTRUCTIONS
II or IIIw/Memory& FanTrim
Basic Overview
The AcuTron digital control board with Memory was designed to give you flexibil-
ity on how you want to operate your stove. The AcuTron can be operated as a
MANUAL control or by a THERMOSTAT. When operating in the Thermostat
option, you can also choose to run your appliance in the ON/OFF mode or the
LOW/HIGH mode.
The
START
or
FEED RATE
touch pad allows electricity to flow to your stove's
electrical components for 15 minutes. If after 15 minutes your stove has heated
to normal operating temperatures your stove will continue to run. If the fire does
not light and/or burn properly, the electricity to your stove's components will be
shut off at the end of 15 minutes.
The
FAN SPEED
controls the speed of the room air fan. This fan blows room air
through the heat exchange tubes and back into the room. When the
FEED
RATE
is set to a higher position, the
FAN SPEED
should be set higher and visa
versa. To achieve optimum heat transfer it is recommended to set the FAN
SPEED to LOW or LOW/MED when running the FEED RATE at 1 or 2, and
Fan on MED OR MED/HIGH on FEED RATE #3 or 4.
When the
START / FEED RATE
is
ON
, the
AUGER CYCLE
LED
will turn on
when the auger is active. When the
OFF
touch pad is pushed [OFF], the auger
motor will not run, fuel stops feeding and the fire will die.
The
FEED RATE
works in a synchronized manner setting both the fuel rate and combustion air at the same time. When
fuel is increased by setting the
FEED RATE
higher, combustion air is automatically increased and visa versa.
MEMORY
— If a power outage occurs, the board will remember the function it was performing and return to that function
when the power returns.
MODE OF OPERATION SELECTION
- All 3 modes of running the control are now activated by using the OFF button to
program. (More detail to follow in this section)
FAN TRIM
—Allows for fine tuning of the exhaust fan, at the Lower (#1) Feed Rate. This aids in adjusting for fuel, eleva-
tion, venting and heating requirements
as desired
as desired
Memory &
Fan Trim
PelPro Appliances www.pelprostoves.com 21
