t
Page 8
u
t
Page 9
u
INSTRUCTIONS
INSTRUCTIONS
Operating instructions for the main unit
Buttons
Indication lights
The product is activated or shut down.
Touch the oscillation button, to activate or to shut down the oscillation
Buttons
Function description
Startup/Standby
Timer
Wind type
Oscillation
Wind speed
Cool wind
Switch wind speed to low-speed ,, medium-speed , and high-speed .
Select among these three types of wind: Normal wind (3 wind speed
settings can be used), Natural wind (speed changes from high to low),
and sleep wind (quiet and low speed).
Shutdown timer: first press "Startup/Standby" button and set the
preferred function. After that, select "Timer" button. The timer function
allows you to program the unit for up to 7 hours of use.
Startup timer: with the "Startup/Standby" button off, press the "Timer"
button. The timer function allows you to program the unit to start within
7 hours.
Use this function to activate cool humid air.
If indicator light flashes, please add water.
Remote control button description
NOTICE
• The remote control should be used within 16 feet of the front of the product and
point within 30 degrees of the sensor.
Batteries should be recycled in accordance with applicable laws and regulations.
•
Note: Both control panel operation " " and remote control " "
change wind type;
Both control panel operation " " and remote control " "
activate/deactivate cool wind;
Set oscilltion
mode
Startup/Standby
Set timer
"+" increase wind speed
"-" decrease wind speed
Set wind
type
Start/stop
cool wind
AAA Battery, 1.5 V
Use manganese or alkaline batteries of type
"AAA". Do NOT use rechargeable batteries.
CLEANING AND MAINTENANCE
NOTICE
•
Disconnect the power before cleaning the product. Clean after the product is shut
down for at least two minutes.
Prevent from using any abrasive tools and solvents that may damage the surface
to clean up the product. Detergent can be used in the cleaning, and then wiped
clean with dried cloth.
Do NOT wash the machine body with water directly, and wash disassembled parts
with a soft brush and then install them after they are cleaned and dried.
Do NOT make any modifications to the product. It is recommended that this
product should be checked and cleaned regularly in order to extend its service
life.
•
•
•
