Page 10
Page 11
SERVICE GUIDE
CLEANING AND MAINTENANCE
Guidance on the disassembly and installation of honeycomb filter
and frame
1 Remove the honeycomb filter frame. 2 Rotate the buckle at the
bottom of the frame
4 Re-install the honeycomb filter
into the frame and then place
the frame back on the main
unit
3 Take out the honeycomb filter for
cleaning.
Replacing water
After stopping the cool wind function for
at least 2 minutes, water can be added
to the water tank. Make sure that the
water does not exceed the "MAX"
(maximum) indication and is above the
"MIN" (minimum) indication.
Troubleshooting
Please check the following items before asking others for inspection
or maintenance.
Problem
Cause
The product cannot be
operated after being
installed.
Less wind is being
produced.
Cool wind function is not
working
.
The power cord is not plugged in or has bad
contacts.
The machine switch is faulty.
The wet curtain is dirty, and should be cleaned on a
regular basis.
Check if the water tank has the correct amounts of
water.
MAINTENANCE INSTRUCTIONS
The product requires little maintenance. Do not try to fix it by your-
self. Refer it to qualified service personnel if service is needed.
1. Before cleaning and assembling, product must be unplugged.
2. To ensure adequate air circulation, keep the air inlet and outlet free
of dust. Do not disassemble the product to remove dust.
3. Please wipe the exterior parts with a soft cloth and mild detergent
only.
4. Do not use any abrasive detergent or solvents to avoid scratching
the surface. Do not use any of the following as a cleaner: gasoline,
thinner.
5. Do not allow water or any other liquid into the product housing or
interior parts.
CLEANING
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with a soft cloth moisten with mild
soap. Thoroughly remove soap film with dry cloth.
