PELLA
®
INSYNCTIVE
™
BRIDGE PRODUCT GUIDE
|
6
BRIDGE will communicate with and attempt to sync to the home
automation system.
• If successful, BRIDGE will issue a long tone and light will turn
green prior to tone signal ending.
• If unsuccessful, BRIDGE will continue to flash a blue light for
up to 2 minutes. Repeat the sync process.
• If unable to sync, see troubleshooting information on page 12.
NOTE:
When BRIDGE is synced to a Z-Wave home automation system,
the light will not blink blue following power startup.
Once BRIDGE is enrolled to the home automation system additional
devices must be enrolled using the Z-WAVE PROCESS not STAND-
ALONE MODE. STATUS INDICATOR is the only device that is capable
of enrolling in STAND-ALONE MODE after BRIDGE is connected to
home automation.
3. Sync Your Pella
®
Insynctive
™
Smart Products
BRIDGE is now ready to sync to Insynctive devices.
Refer to the Product Guides at Insynctive.Pella.com/Support
for instructions on how to sync with BRIDGE.
NOTE:
Pella Corporation provides no warranty and is not
responsible for the function, reliability, or any damage caused
by non-Pella products.
Contact your home automation system provider to sync
via Ethernet cable.
FOR SYSTEM PROVIDERS:
Follow steps for Without
Home Automation (Stand-Alone Mode) on page 5.
Upon completion of stand-alone mode steps, visit
Insynctive.Pella.com/HomeAutomation for Pella
Insynctive programming details.
FACTORY RESET BRIDGE
It may be necessary to restore BRIDGE to its factory default state.
This will delete all devices that have been learned to BRIDGE and
any association to a Z-wave gateway. To perform a Factory Reset:
• Press and hold both buttons while plugging BRIDGE into
wall outlet.
• Continue to hold the buttons for about 5 seconds until
BRIDGE sounds a long beep and flashes green to
acknowledge deletion.
DETAILED INSTRUCTIONS
(continued)
BATTERY
COVER
ETHERNET
PLUG
PLUG
LIGHT
SYNC
BUTTON
TEST
BUTTON