Installation Instructions
Step 2 – Selecting the Faucet Location
NOTE: The drinking water faucet should be positioned with function, convenience, and
appearance in mind. An adequate flat area is required to allow faucet base to rest securely.
The faucet fits through a 3/4-inch (19mm) hole. Most sinks have pre-drilled 1-inch (35 or 38mm)
diameter holes that may be used for faucet.
a)
Line bottom of sink with newspaper to prevent metal shavings, parts, or tools from
falling down drain.
b) Place masking tape over the area to be drilled to prevent scratches if drill bit slips.
IMPORTANT:
To avoid damaging the sink, consult a qualified plumber or installer for drilling
procedures in porcelain, granite, or stainless steel.
c)
Mark hole with center punch. Use a 1/4-inch (6mm) drill bit for a pilot hole, then,
using a 3/4-inch (13mm) drill bit or hole saw, drill a hole completely through the sink.
Smooth rough edges with a file.
Step 3 – Mounting the Faucet
a)
Locate the faucet installation packet.
b) Slide the escutcheon plate then the rubber gasket onto the threaded shaft of the faucet.
c)
Slide the threaded shaft of the faucet into the drilled hole.
d) From under the sink, slide the large washer and lock washer on the threaded shaft.
e)
Thread on the lock nut. Tighten lock nut by hand until tight.
Caution: Do not over-tighten the lock nut. Hand tighten only. Do not use pliers or
wrench to tighten.
Step 4 – Mounting the system
a)
Center system between water supply adapter and drinking water faucet.
NOTE: Allow 1.5 inches (38mm) clearance below system to enable filter
cartridge changes.
NOTE: In the following step, leave enough space (approximately 1/2-inch (13mm))
between the head of the screw and the wall to easily slip system into place.
b)
Install mounting screws at least 15-inches (380mm) from cabinet floor and
9 1/4-inches (235mm) apart. Place system over screws on wall and slide sideways.
Tighten screws.
Caution: Make certain system is firmly attached to wall to prevent possible damage from
falling.
Step 5 – Connecting Tubing to the Faucet
Caution: Do not over-tighten compression nut. Use caution not to bend or crimp tubes when securing.
a)
Locate compression nut pieces (3) in installation kit and faucet package.
b) Attach compression nut pieces (3) to one end of tubing by sliding the nut and ferrule onto the
tubing; then insert the sleeve into the tube.
c)
Attach tube with compression nut assembly to faucet stem by inserting tube into the faucet
stem opening. Tighten nut.
NOTE: All nuts must be retightened when the system reaches projected operating temperature.
5
