pela tools 511754, Manual

Page: 24 / 72

The cover plates in place.
Instruction manual:
Preparations
• Check all oil hoses. The lift may be started
provided that no leaks occur.
• If safety equipment does not work or is
missing, do not use the lift.
• The lift may only lift and lower vehicles whose
center of gravity is positioned in the middle of
the platforms.
• The operator and authorized assistants must
be at a safe distance when the lift is operated.
• When the lift is raised to the desired level, turn
off the power to prevent the lift from being
accidentally operated.
• Make sure that the safety catch is activated
before you start working with the vehicle and
that no one is under the vehicle when the lift is
operated.
A
F
E D C B G H
Description of control box
A Main switch
B Emergency stop
C Raising the lift
D Warning light, activated when lowering the lift
below 20 cm
E Current indicator
F Down I, lowering the lift
G Down II, lowering the lift below 20 cm
H The lift goes down and rests on the catch
User instructions
Raise the lift
• Make sure you understand the functions of the
lift before starting.
• Drive and park the vehicle’s gravity center
centered over the platforms.
• Place the 4 rubber blocks under the car’s lifting
points (see the car’s manual) make sure that
the weight is evenly distributed on the blocks.
• Turn the power switch (A). Press up (C) until
the blocks make contact with the lifting points.
Make sure it looks good.
• Continue to raise a little bit and make sure that
the weight of the car falls centered over the
blocks in a safe way.
• If everything seems OK, continue to raise to the
desired height. Important: lower the lift so that
it rests on the safety catches (H).
• Turn the switch to the OFF position to prevent
the lift from being accidentally operated. Once
again, check the stability of the vehicle and
that the safety catches are in operation before
starting working with the vehicle.