pela tools 510425, Manual

Page: 21 / 34

Installation advice
Unless specifically stated, our lift is for indoor use
only. It should be mounted on an even and stable
concrete floor. Do not install the lift on expanding
concrete beams or on a second or elevated floor
without first consulting a building architect. Make
sure that the space around or above the lift is free
of obstacles such as heaters, beams, power lines,
etc.
Make an installation layout:
When determining the installation location, first
select the location of the main post. From this
place, two diagonal lines of the same length are
drawn. The lines are marked with masking tape or
with chalk.
Undress the packaging plastic, place some
distances between the two posts before
unscrewing the upper one from the frame, or hang
the upper post in a crane / motor lift or hold with
a truck. Be careful that none of the posts fall over
or fall to the floor, as the attachment points for the
accessories may be damaged. Remove the posts
and the loose parts from the packages and place
them where the lift is going to be installed.
Read the manual and check that, all parts are
included.
Raise the post. The column with attachment point
for the hydraulic unit should be raised first. Be
careful that none of the posts fall over or fall to the
floor, as the attachment points for the accessories
may be damaged.