pela tools 489050, Manual

Page: 6 / 8

into the sleeve (#10).
A. To remove shaft 1, remove the sleeve (#10)
off the right end of shaft 1.
B. Next, at the top of the left stand, loosen hex
bolt (#3).
C. Pull the right end of the shaft 1 outward.
5. Mounting shaft 1
A. Reinsert the right end of shaft 1 into the hole
in the right stand.
B. Tighten hex bolt (#3) on the top of the left
stand.
C. Push the sleeve (#10) onto the end of
shaft 1.
Operation
Before using, check the mounting and adjustment
of this machine. Rotate the handle (#23) and check
whether the four gears (#19, #30) have good, firm
contact with each other. Shafts 1, 2 and 3 should
be clean and free of metal debris. Refer to the
illustration below, and on the last page.
Forming rolls
1. Insert the steel plate between shaft 1 (#8) and
shaft 2 (#20).
2. Rotate the handle (#23) to form the metal roll.
3. If the diameter of the metal roll is not correct,
turn the adjusting bolts(#22) clockwise to
decrease the diameter, of counter clockwise to
increase the diameter of the roll.
4. To remove the finished roll, pull out sleeve
(#10) on the end of shaft 1 (#8), nearest the
handle (#23), and swing shaft 1 out of the right
stand. Then remove the steel roll from shaft 1.
Forming rings
The half-round slots on the right side of shaft 2
(#20) and shaft 3 (#7) can be used to form rings of
various dimensions.
1. Insert the steel in half-round lot of shaft 2 (#20)
or shaft 3 (#7).
2. Rotate the handle (#23) to form the metal ring.
Warning: Keep the hands away from the shafts and
metal plate during operation. Do not attempt to
form rolls from materials other than those
specified.
Part Description Qty
1 Left stand 1
2 Nut M12 1
3 Hec Bolt 1
4 Support Bushing 4
5 Square Bushing 1
6 Flat Key 3
7 Shaft 3 1
8 Shaft 1 1
9 Right Stand 1
10 Sleeve 1
11 Washer 1
12 Spring Washer 1
13 Screw 1
14 Cover 1
15 Hex Bolt 4
16 Spring Washer 4
17 Washer 4
18 Bearing 1
19 Small Gear 2
20 Shaft 2 1
21 Base 1
22 Adjusting Bolt 2
23 Handle 1
24 Locking Screw 1
25 Hex Nut 1
26 Handle Bushing 1
27 Hex Bolt 1
28 Washer 2
29 Spring Washer 2
30 Large Gear 1
31 Small Shift 1
32 Hex Bolt 2
33 Locking Screw 2
34 Pin 2
Parts