Peimar PSI-J51-48-BT, Manual

Page: 46 / 56

46
EN
Note:
•
Check that the DC switch is turned off during installation to avoid short circuits
caused by incorrect operation when wiring the battery.
• Use the battery cable in the original packaging.
DIP switch setting.
When a battery is connected, the DIP switch does not need to be set.
If there are two or more batteries to connect, refer to the following DIP switch configuration
table.
4.3 Inverter Connection
Follow the steps listed below to connect the battery to the inverter:
Step 1: unscrew the waterproof cover of the inverter corresponding to the battery inputs,
then pass the battery cable through the waterproof hole:
Configurations
DIP switch on
Battery NO.1
DIP switch on
Battery NO.2
DIP switch on
Battery NO.3
DIP switch on
Battery NO.4
1
2
3
4