Peimar PSI-J51-48-BT, Manual

Page: 41 / 56

41
EN
Make sure that the wall is capable of mounting screws and supporting the weight of the
battery pack before installation. Mark the location of bracket's holes on the wall and drill
the holes. Then use a rubber hammer to drive screws into the holes. (dimensions in mm)
Fix the brackets in the marked position with hex screws.
Be careful when installing the device.
First remove the plug from the waterproof nut, then insert the cable gland. Tighten the
cable gland after passing the connector. Doors that do not require wiring should remain
in their original state.