BTHFCK User’s Guide
Revision: A
Page
8
8
8
Setup and phone registration (Pairing)
The first step in using the kit is to ‘register’ your Bluetooth-enabled phone with the car kit. This process, usually called
‘pairing’ or ‘registration’ allows your phone to communicate with the handsfree system and ensures that other phones
cannot inadvertently do so.
Please follow the steps below to complete this process:
(1)
Turn on you cellular telephone and ensure that it is Bluetooth-enabled and supports either Headset Profile
†
or
Handsfree Profile
†
.
(2)
Turn on your vehicle ignition and ensure the LEDs are turned on for 2 seconds. This will take a few seconds.
(3)
We now need to enter the setup mode to register your phone. Please do the following steps.
(4)
Press EINBETTEN
[
‘Hook Ready’
or
‘Ready’
[
Say
“Set-Up”
[
Say
“phone pairing” ”
[
Say
“pair”
[
‘Please register phone as mentioned in phone manual.’
(5)
The kit will wait for approximately
2 minutes
to have a Bluetooth phone pair with it. At this point, you need
to activate the Bluetooth pairing procedure in your phone as outlined in your manual. You need to set the
phone to “Add Device” or to have it search for all available devices
(6)
Once the phone has found the kit, it will display this information on the phone. It should display some message
that it has located “Peiker HFK”. The kit will continue to be silent. Continue to follow the phone’s pairing
procedure until it asks you to enter a password. Enter “0000” on the phone’s keypad and select hit the yes/dial
key on the phone. The phone will then complete the pairing process and you should hear a prompt from the kit
saying
‘pairing completed
’
(7)
If the kit does not find any device (
‘Handsfree-Profile pairing failed, would you like to pair with headset-
profile?’)
, it could be that you do not use a handsfree mobile. You can try to pair a second time with only
headset-profile. Use this mode only, if your mobile does not support the handsfree-profile. If your phone does
support handsfree-profile, say
“no”
and start with (1) to try again.
(8)
You have now completed the registration process and your phone is ready to be used with the car kit.
Note that you can pair up to 5 phones with the PEIKER Bluetooth kit. Only one phone will be active (i.e. able to use the
handsfree system for calls at any one time. The last connected phone will always have the highest priority when the unit
tries to connect with a phone. If the last connected phone is not available, then the kit will look for other phones stored
in it’s memory (other phones that have previously been paired), in order of its priority list. If you pair a sixth phone,
then the phone which was not used for the longest duration, will be removed from the kit.
After completing the registration process, your Bluetooth Car Kit is ready for everyday use.
Initial Requirements
Ignition Switched On
→
Your vehicle ignition must be switched on. It takes approximately 3 seconds after
turning on your ignition for the kit to become active. The LEDs are turned on for two seconds.
Bluetooth in Phone is Active
→
The Bluetooth communication mode must be activated in your cellular phone.
Phone Distance
→
The handsfree kit will operate with the phone up to 20 feet. The quality of the audio signal
will deteriorate as the phone is moved further away from the vehicle. The phone does not need to be in the
open (i.e. it can be in a purse or pocket) to operate but it should not be blocked by metal (i.e. do not place it in
the trunk).