1
2
3
4
6
Attention
：
When Continuous Scanning Mode set,the scanner enters into continuous reading code without pressing switch button.Under
continuous scanning mode, the scanner can set the scanning interval time and the interval time unit as 500ms, parameter range is
0-7500 ms. Under continuous scanning mode allows continuously read the same barcode via setting scanning interval time.
Read the same barcode twice in 0.1 seconds, the time interval can be set between 0 and 12.0 seconds.When set to 12.7 seconds means
not allow to read the same barcode.The numerical must have three numbers, zero shows if less than three numbers.
For example: the scanning interval for the same barcode for 2000 ms steps as follows:
1
〝
Enter Into Settings
〞
2
、〝
Scanning the Same Barcode Interval Time
〞
3
、〝
Parameter Barcode
〝
0
〞〝
2
〞〝
0"
4
、〝
Quit Settings
〞
Security Level Settings
(Attention: The higher the level, the lower the reading barcode error rate and slower the speed)
Enter Into Settings
Quit Settings
Barcode type settings
Open The Code ID Before Barcode Close The Code ID Before Barcode
Restore Default The Code ID
