Peg-Perego Viaggio 0+1, Instructions For Use Manual

Page: 26 / 112

26
suddenly, it could injure the passengers.
• Do not use the car seat if more than seven years have
elapsed from the date on the frame. The natural aging
of the materials may mean the car seat does not
comply with the laws on safety any more.
• Do not use accessories that have not been approved of
by the manufacturer or competent authorities.
Instructions for use
UNIVERSAL CATEGORY - Belted
Group 0+
Fastening with seat belts
1•
IMPORTANT: For the correct use of the Viaggio
0+1 Switchable car seat in Group 0+ mode, you
must:
- Extract, from under the seat, the recline body. To
extract it, press the handle and pull it towards you
extracting the base (arrows A and B).
- Use the lever (arrow C) to recline the seat to its
highest position.
2• Viaggio 0+1 Switchable car seat correctly structured to
be used as Group 0+ car seat.
3• Apply the Viaggio 0+1 Switchable car seat on the seat
so that it is rear-facing, as shown in the picture.
Fit the car seat belt between the frame and the seat
following these steps:
_ slip the belt into the webbing guides first (arrow A);
_ fasten the seat belt to the seat until it clicks (arrow B);
4• thread the seat belt in the blue webbing slot on top
(arrow C).
IMPORTANT:
hold the belt and pull it firmly, so
that the Viaggio 0+1 Switchable is as close as possible
to the car seat (arrow D).
Instructions for use
UNIVERSAL CATEGORY - Belted
Group 1
Fastening with seat belts
5• IMPORTANT: In order to properly use the
Viaggio 0+1 Switchable child seat as Group 1 , it is
necessary to:
- reposition the casing within the base of the child
seat.
Press the lever and push inwards as indicated in
the figure.
6• Place the Viaggio 0+1 Switchable car seat on the
vehicle’s seat, facing in the normal direction of travel of
the vehicle, as shown in the figure.
7• To make it easier to pass the vehicle’s safety belts
through the back of the car seat, it is necessary to
recline the seat to the lowest position by operating the
lever, as shown in the figure.
8• Pass the vehicle’s safety belt between the frame and
the shell of the car seat.
9• The lap belt must pass through the low slots marked in
red. Fasten the belt, ensuring that it clicks into place.
10• Check that the lap belt has gone through the low slots
marked in red and tighten it.
11• Bring the backrest back to the vertical position by
pulling the handle below the seat (Fig. A) and pushing
the child seat as in figure (Fig. B).
12• To complete the securing procedure in a vehicle, use
the Steady Fix device. Open the clip and pass the
diagonal strap through it, ensuring that it is taut and
not twisted (Fig. A). Close the safety tab (Fig. B).
13•
IMPORTANT: Take hold of the safety belt and pull it
upwards firmly to fit Viaggio 0+1 Switchable more
closely to the seat of the vehicle (Fig. C) .
Once the procedure is complete, it is possible to
recline the seat to the desired position (See Point 6).
How to put the child in the Viaggio
0+1 Switchable car seat
14• Before sitting the child on the stroller, release the safety
harness by pushing the red button in the buckle of the
leg divider strap.
15• Lift the safety harness and attach the buckles to the
elastics in the sides.
16• Sit the child in the stroller and adjust the safety straps
round the child’s shoulders and waist, as shown in the