EN-26
Original User Guide | Pedelec Groove Next
PLEASE NOTE
The opening for the cable guide must face downwards, and/or
upwards for overhead mounting.
Make sure that the brake disc is placed exactly in the
middle between the brake shoes.
Do not forget to install all the washers.
3. Tighten the axle nuts (M12) using an 18 mm spanner turning clockwise
and tighten via torque of 30 to 40 Nm. Ensure that the rear wheel is
correctly centred.
For 3. Exploded view of drive mounting
Axle nut
Drive
Drive cable
Axle nut
4. Reinsert the Pedelec battery.
DANGER
Observe the prescribed tightening torque. Failure to comply can
result in screws/bolts becoming loose, tearing away or fracturing. If
that happens while you are riding the bike, components may come
off and you could have a severe crash. If screws are overtightened,
components can also be damaged.
If no value is shown on the component, use the torque settings from
Section
10. Torque settings Page EN-55
3.15.2 Replacing the front wheel
Removing the front wheel
1. Remove the Pedelec battery.
PLEASE NOTE
Detach all cables from the front wheel (e.g. light cables), otherwise
you could tear them.
2. Insert a 6 mm Allen key into the threaded axle and turn anticlockwise
until it releases.
3. Remove the threaded axle.
4. Remove the front wheel.
