Peavey Tube Fex None, Operation Manual

Page: 25 / 62

HOW TO CONTROLLER
For this example let’s walk through the steps required to create a wah” effect using a continuous
controller pedal. Assuming you have a continuous pedal hooked up to the Tube Fex via a MIDI foot controller,
first select or write a patch that has the envelope filter
(EF)
effect and store it. Then push the
Edit
button,
select
EF
and push the
Edit
button again. Next, push the
Global
button until the following screen is displayed:
TP LP
Move the cursor under RC and use the and
A
buttons to select channel
1.
For this example we will assume
your foot controller has channel 7 as a continuous channel send. Next push the
Global
button until the
following screen is displayed:
P r a m
Move the cursor under Pram and use the and
A
buttons to select Freq. Next move the cursor under
and select Next move the cursor under Ch and select RCV. Next move the cursor under S
C
and
select It is to note that the scale can be set from allowing normal or reverse wah
effects. You can set the scale anywhere in between to adjust the effect to your tastes. Next press the Edit button
and move the cursor under
Sn
and select a sensitivity level. Try to start. Next move the cursor under
Fq
and select a frequency, try Next move the cursor under Rs and set the resonance, try 52. Next move the
cursor under Ty to select a filter, try Next move the cursor under Mx and try a mix level of 50%. Now
work the continuous controller pedal to try the effect. Adjust the envelope filter parameters and the scale to
suit your taste. Press the
Store
button to save the settings and continuous controller to your preset.
Note: If you get volume control instead of wah wah, push the Global button until the following screen is
displayed:
Move the cursor under and change the setting to
OFF.
Now try your effect. can also use the
parametric EQ to create this effect.
26
Chapter 4
Using