To dump a set of presets to an external device (or another Tube
In the MIDI menu display press the
or
arrow
button until the cursor is under
DS
(Dump Set).
the or buttons to select the set
(O-12)
to be dumped. Press the
button to execute the
dump. The display will briefly show:
Note:
The
transmit channel of the Tube Fex must be set the same as the
receive channel on the
external device unless the external device is set to OMNT.
To load sets or presets to their original locations from an external storage device or another Tube
set the
receive channel to match the MIDI send channel on the external storage device (or other
Tube
Then send the set or presets to the Tube Fex. That’s all there is to it!
Note:
See the owners manual of the storage device for instructions on sending
dumps.
To load sets or presets to a new location. Set the MIDI receive channel to match the
send channel on
the external storage device or Tube Fex. Then select
LP
(Load Preset) if loading a preset to new location
or
LS
Set) if loading a set to a new location. Select the new location. Then send the
or set to
the Tube Fex.
Note:
The
receive channel of the Tube Fex must be the same as the channel the data was
transmitted on. An error message will appear if they are not the same. If this occurs, set the receive
channel to the channel shown in the message transmit again.
A set of special system exclusive editing commands is available on the
This will allow remote
programming of all effect parameters, effect levels, the effect chain, and
controller assignments.
The edit buffer can also be stored in any user preset location remotely. These
heard
immediately, but will not appear on the screen unless the
being edited is currently selected.
Appendix B
for complete remote editing command information for programmers of
devices
Chapter 4
Using
Summary of Contents for Tube Fex None
Page 1: ......
