Peavey Audition 110, Operating Manual

Page: 3 / 16

FRONT PANEL FEATURES
INPUT (1)
The input jack will accept signals from all types of guitar pickups.
VOLUME (2)
Controls the volume level of the Clean channel.
CHANNEL SELECT SWITCH (3)
Allows selection of the Lead or Clean channel. The “in” position of the switch selects the Lead channel and
the “out” position selects Clean.
NOTE: Channels may also be selected with the remote footswitch. If remote selection is desired, the chan-
nel switch must be in the “in” (Lead) position.
PRE GAIN (4)
Controls the input gain of the Lead channel.
POST GAIN (5)
Controls the overall volume level of the Lead channel. The final level adjustment should be made after the
desired sound has been achieved.
CD/TAPE INPUT (6)
The CD/Tape input can be used to route the Headphone Out signal of a CD player, tape player, etc. into the
CD/Tape input. Connect the CD or tape headphone output using a shielded cable to the CD/Tape input jack.
This signal is mixed with the guitar signal but is not affected by the EQ.
LOW, MID, & HIGH EQ (7)
Passive tone controls that regulate the low, mid, and high frequencies of both the Clean and Lead channels.
REVERB (8)
Controls the overall reverb level.
HEADPHONE JACK (9)
This stereo jack allows signal to flow to both sides of any stereo headset for private
headset may be used, but is not recommended.
listening. A monaural
REMOTE SWITCH (10)
to select the Lead or
Provided for the connection of the optional remote footswitch. The footswitch is usec
Clean channel.
NOTE: The Channel Select switch must be in the “in” position in order for the footswitch to function properly.
3