Pearl VX RSPRO R, Owner'S/Operator'S Manual

Page: 8 / 28

– 8 –
SAW STAND ASSEMBLY
FOLDING STAND
1. It is recommended that adjusting the
folding leg be done by at least two people.
2. Remove the detachable wheel assembly
and stow it on the frame.
3. Shift the cutting head away from the end
of the frame where the leg is being
adjusted. Tighten the cutting head
carriage knob to hold the head in place.
4. Loosen the knob that is locking the leg in
place.
5. Lift the saw slightly to give the leg room to
rotate into stow/deployed postion.
6. Slide the leg in place and tighten the knob.
7. Repeat steps 2-4 as required to the
remaining legs.
EASY TRANSPORT
1. It is recommended that adjusting the
folding leg be done by at least two people.
2. Remove the detachable wheel assembly
and stow it on the frame.
3. Shift the cutting head away from the end
of the frame where the leg is being
adjusted. Tighten the cutting head
carriage knob to hold the head in place.
4. Loosen the knob that is locking the leg in
place.
5. Lift the saw slightly to give the leg room to
rotate into stow/ deployed postion.
6. Slide the leg in place and tighten the knob.
7. Insert the detachable wheel assembly in
either the frame/leg position depending
on need.
8. Make sure the head is on the side closest
to the wheels before transporting the saw.
Detachable
wheel
assembly
Wing screws
(4) to retract
or deploy the
folding legs
Cutting head
carriage knob