– 13 –
8. Connecting the Water Pump
A. Attach the provided adapter to the water
pump.
B. Hand tighten the adapter.
Do not use a
wrench
as it can strip the thread.
C. Connect the clear tubing to the male
section of the adapter until it fits securely
See Figure 11.
To Remove the Bearing Housing:
1. Remove the screws (5 screws–VX7.2XL •
3 screws–VX10.2XLPRO) on the belt guard.
2. Remove the belt guard.
3. Loosen (but do not remove) the
adjustment screw behind the mounting
plate and the 4 screws on the motor base
to remove the belt.
4. Remove the blade lock nut and remove the
blade (if there is one present).
5. Remove the 4 screws on the mounting
plate closest to the cutting head handle to
remove the bearing housing (including the
attached pulley and inner flange.)
To Install the New Bearing Housing:
1. Be sure that you have completed the
instructions above to remove the old
bearing housing.
2. Open the box and carefully place the flat
portion of the new bearing housing face-
down on a towel situated on a flat surface.
3. Secure the cutting head in a completely
horizontal position.
4. Slide the new bearing housing with the flat
portion facing upwards onto the 4 screws
located below the mounting plate.
Take
care not to damage the inner flange.
Lock the bearing housing into place by
using brackets and nuts.
5. Pull the motor toward you, place the belt
on the pulleys, and tighten the motor
position adjustment screw. Be sure to
leave some slack on the belt.
6. Align the belt by adjusting the motor pulley
after loosening the hex screw.
WARNING:
Do not adjust the bearing housing pulley.
After aligning the belt, tighten the hex
screw.
7. Replace the belt guard and lock into place
using 3 screws.
The recommended cutting depth is 1/4" below the cutting
table surface. To adjust the cutting depth, loosen the
mounting plate adjustment knob so that the blade is 1/4'
below the top of the cutting table’s surface.
WARNING: Setting the blade too low may damage the
cutting table and if set too high, the blade may grab the
material being cut, causing damage and possibly
injury.
Figure 11
Adapter
Water tubing
x. BEARING HOUSING REPLACEMENT
BLADE DIAMETER
CUTTING DEPTH
6 inch
1-1/2 inch
7 inch
1-3/4 inch
8 inch
2-1/4 inch
9 inch
2-3/4 inch
10 inch
3-1/4 inch
Figure 12
xi. CUTTING DEPTH
Summary of Contents for VX10.2XLPRO
Page 23: ...23...
