Pearl Abrasive VX10.2XLPRO, Owner'S Manual

Page: 12 / 24

5. Aligning the Blade to the Table
• While cutting, the material being cut must
move in a straight line parallel to the saw
blade. If the blade is out of plane it will
bind at one end of the cut. To align the
blade requires cutting a tile (securely
against the table back stop) while
checking for binding at trailing edge of
blade (farthest away from operator).
See
Figure 7.
If adjustment is required, loosen four
bolts at top of vertical arm. Rotate
complete motor assembly as required
until alignment is attained. Tighten all
four bolts and re-check alignment.
6. Tub & Tray
• Insert the large rubber stopper in the
drain hole.
See Figure 8.
7. Positioning the Saw in the Tub
A. Place the saw in the tub positioning the
Vertical Arm on the same side as the relief
in the tub shown in
Figure 10.
B. Line the saw up with the molded guides in
the base of the tub.
Blade
Tile
Figure 7
Rubber Stopper
Tub
Figure 8
Figure 9
Attaching Drip Tray to Tub
STEP
1
STEP
2
Figure 10
Relief side of the tub
Figure 6
Table roller adjustment
4 hex-screws
screw
– 12 –
VX7.2XL
shown.