– 10 –
fuse or circuit breaker that supplies power
to the tool. Then unplug and examine for
presence of water in the receptacle.
21. Extension Cords
• Use only extension cords that are
intended for outdoor use. These extension
cords are identified by a marking
“Acceptable for use with outdoor
appliances; store indoors while not in
use.” Use only extension cords having an
electrical rating not less than the rating of
the product.
Refer to chart on page 21.
Do not use damaged extension cords.
Examine extension cord before using and
replace if damaged. Do not abuse
extension cords and do not pull on any
cord to disconnect. Keep cord away from
heat and sharp edges.
Always
disconnect the extension cord from the
receptacle before disconnecting the
saw from the extension cord.
* Ground Fault Circuit Interrupter (GFCI)
protection should be provided on the
circuit(s) or outlet(s) to be used for the
tile saw. Receptacles are available having
built-in GFCI protection and may be used
for this measure of safety.
Features:
• Cutting table marked in inches for precision
cuts.
• 14” cutting table provides more support during
larger cutting jobs than the standard 11”
cutting tables.
Using 90˚ Rip Guide:
1. Set the rip guide by positioning it on the
desired dimension and tighten the threaded
knob. Make sure that the rip guide is firmly
tightened to avoid slippage. The rip guide can
be used for 90˚ rip cuts from both the left and
right side.
2. After the rip guide is positioned for the desired
cut, place material flat against the rip guide and
the table measurement rail.
3. Simply line-up the material being cut with the
appropriate pre-marked lines on the cutting
table surface.
4. Now you are ready to make your cut.
Making Miter Cuts (Using Optional Miter Block):
1. For miter cuts, place the lip of the miter block
on the measurement rail, with the threaded
knobs facing you.
2. Tighten the threaded knobs to secure the miter
block in place.
3. Place material onto miter block and you are
ready to cut.
viii. USING THE CUTTING TABLE
Figure 4
Cutting large tile
VX10.2XLPRO
and
VX7.2XL
can cut a
24"
tile and diagonally cut a
18"
tile.
TOOL
Figure 3
Drip Loop
Supporting
Surface
Power Cord
Drip Loop
VX7.2XL
shown.
Summary of Contents for VX10.2XLPRO
Page 23: ...23...
