1. File(F) Menu
Open (O) Opens a stored measurement chart from TXT-file
SAVE Stores the current measurement chart in TXT format
EXIT (e) Closes the program
2. Set up(S) Menu
Set the software language
3. Set-Window
Change the parameters of your data connection
Close Port
Terminates the data transfer
Port
To change the COM-port of the interface
Bps
To change the serial data connection speed
4. About-Menu
About
Shows the current software version
5. Quick-Start launcher
Use the quick-start launcher for fast data connection and evaluation of the measurement values
6. Info-Window
The information window displays the transmitted device data
7. Graphics/Form- switch
Display the measurement data as graphics diagram or data chart
8. Display
Displays the readings as a graphic chart or table of measured values
To enlarge a section of the graphic chart, drag the left mouse button and drag a selection box
from the top-left to bottom-right of the desired section
To reduce the magnified view, drag the selection frame from the bottom-right to top-left
9. Command Line
In the command line you can enter any direct commands, also some special features can be
entered directly. Please refer to the command table of the included software CD
10. Transmission Indicator
Shows the data sent and received
11. Data Recording Window
Allows remote control of measurement described in the data storage as described in Section
6.1.2
Under
target
specify the desired storage location
Under
Quantity
set the desired number of recorded readings
Under
Interval
set the measurement interval
12. Direct Control
Switch all measurement ranges via software
TIME?
Reads the system time of the multimeter
SET TIME
Synchronizes the system time between the multimeter an PC
Note
: The multimeter system time is written to the data charts if saved to a external storage and
should be synchronized with the pc-system time if necessary
For new software versions visit our homepage www.peaktech.de
-60-
