* Do not exceed the maximum permissible input ratings (danger
of serious injury and/or destruction of the equipment).
* The meter is designed to withstand the stated max voltages. If
it is not possible to exclude without that impulses, transients,
disturbance or for other reasons, these voltages are exceeded
a suitable presale (10:1) must be used.
* Replace a defective fuse only with a fuse of the original rating.
Never short-circuit fuse or fuse holding.
* Disconnect test leads or probe from the measuring circuit
before switching modes or functions.
* Do not conduct voltage measurements with the test leads
connected to the mA/A- and COM-terminal of the equipment.
* The 10A-range is protected. To avoid damage or injury, use
the meter only in circuits limited by fuse or circuit breaker to
10A or 2000VA.
* To avoid electric shock, disconnect power to the unit under
test and discharge all capacitors before taking any resistance
measurements.
* Do not conduct current measurements with the leads
connected to the V/
-terminals of the equipment.
* Check test leads and probes for faulty insulation or bare wires
before connection to the equipment.
* To avoid electric shock, do not operate this product in wet or
damp conditions. Conduct measuring works only in dry
clothing and rubber shoes, i. e. on isolating mats.
* Never touch the tips of the test leads or probe.
* Comply with the warning labels and other info on the
equipment.
* The measurement instrument is not to be to operated
unattended.
* Always start with the highest measuring range when
measuring unknown values.
* Do not subject the equipment to direct sunlight or extreme
temperatures, humidity or dampness.
* Do not subject the equipment to shocks or strong vibrations.
* Do not operate the equipment near strong magnetic fields
(motors, transformers etc.).
-29-
