8. Using the control knobs
8.1. The rotary encoder control knobs have fine and coarse tuning with clicking movement.
Push the knobs to toggle between coarse and fine tuning, notice the subtle changes in
brightness of related LED.
Adjust the knobs to your desired values by trying coarse and fine tuning. The display will
resume its normal brightness after few seconds to confirm your adjustment.
8.2. Connect the equipment to the power supply. Red (+) is connected to the positive polarity
input of the equipment and Black (-) is connected to the negative polarity input of the
equipment.
8.3. Switch on the power supply first and the panel meter & green CV Indicator should light up
again.
8.4. Switch on the equipment and the panel meter & green CV Indicator should still remain in
green.
8.5. You can now operate the equipment. When an operation is finished, switch off the
equipment first and then switch off the power supply.
9. Remote Control Mode
9.1 Remote Control Mode (P 1565 / 1575 / 1585)
There are two methods for remote control of current and voltage adjustment.
Both methods require current remote control part to be set up in order for remote control mode
to be functional, otherwise unit will be in CC mode all the time.
Method A:
Using two external variable DC voltage sources.
Remote Socket Pin Assignment for external variable voltage source
PIN
Functions
Remarks
1
Internal DC +5V
Less than 50 mA
2
Voltage Adjustment
0
– 5 V
3
Current Adjustment
0
– 5 V
4
Ground
5
Output OFF
Short to Ground
6
N.A.
7
N.A.
8
N.A.
CC current setting by remote control.
Short circuit the main output with
12AWG (3,3mm
2
)
wire.
Adjust the CC current using external power supply connected to Pin 3.
Output voltage setting by remote control
Check the output voltage range of the power supply by varying the external voltage source
connected to Pin 2.
-44-