Half-Cadillac & Mat Mode Assembly
Your pole system comes pre-assembled with the push-through
bar installed. Before you assemble the pole system to the
head end of the frame, make sure that the allen set screws
in the frame’s fittings are backed completely out of the center
holes and that there are no obstructions present. Doing so will
prevent the poles from being scratched during installation.
1. Installing the Poles:
A. This step is best performed by two people. With one
person on each side, lift the pole assembly. Orient the
assembly such that the series of 3 eyebolts on each of the
vertical poles faces toward the foot end of the TWS frame.
B. Slide the poles through the fittings. You may need to
gently jostle the pole system back and forth for the poles
to be able to pass all of the way through. Be sure that the
poles rest on the eyebolt located below the bottom fittings.
C. Tighten the 8 Allen Screws with the 3/16” Allen wrench
provided.
