Peak Beam Systems Maxa Beam 400 series, Operation Manual

Page: 7 / 22

7
(D) Setting Beam Intensity on Start Up (after 3 second warm up):
To set light to start up in battery saver mode
(also sets the left function to battery saver on/off) :
To set light to start up in normal mode
(factory default setting) :
To set light to start up in strobe mode
(also sets the left function to continuous strobe mode) :
(E) Setting the Smallest Spot of the Searchlight:
Note: If you notice a delay before the lamp starts moving when rocking the beam conditioning
switch backward to move out of the full spot position, this means that the spot position is set beyond
the point at which the lamp is physically able to move. If this occurs, the spot position should be
reset to a point at or within the physical limits of the lamp’s travel. It is also possible to focus the
lamp “beyond” spot to the point at which the beam begins to widen past the reflector’s focal point.
Rock the beam conditioning switch backward to move of this unfocused position and return back to
desired spot position.
(F) Setting the Widest Flood of the Searchlight:
Note: If you notice a delay before the lamp starts moving when rocking the beam conditioning
switch forward to move out of the full flood position, this means that the flood position is set beyond
the point at which the lamp is physically able to move. If this occurs, the flood position should be
reset to a point at or within the physical limits of the lamp’s travel.
(G) Changing the Strobe Rate or Duty Cycle:
To follow this procedure the searchlight must be set in the continuous strobe mode (see section (B)
above).