14
To Recharge a NiCad Battery with a Drop-In Trickle Charger:
1)
Set input supply voltage switch to the desired voltage.
2)
Plug the wall adapter into an outlet and connect its output connector to the drop-in charger.
3)
Place the NiCad battery (with or without searchlight attached) into the charger. The battery
will be charged through the contacts on the bottom of the battery.
4)
The battery will recharge in approximately 18 hours.
5)
Disconnect the battery from the charger.
To Recharge a NiCad Battery with a Plug-In Trickle Charger:
1)
Set input supply voltage switch to the desired voltage.
2)
Plug the wall adapter into an outlet and connect its output connector directly to the NiCad
battery.
3)
The battery will recharge in approximately 18 hours.
4)
Disconnect the battery from the charger.
Maxa Beam Optical Filters
A full line of selective band-pass filters and alternate beam pattern filters are available for the Maxa
Beam searchlight. Each filter is securely mounted in a high impact copolymer ring that attaches
over the front lens of the searchlight. The ring is held in place by a positive locking technique that
requires no tools and is easy to install or remove in seconds with only a quarter turn.
MBA-1500 Amber Smoke/Fog Filter:
This filter has been optimized to produce an intense amber
beam for maximum penetration in fog, haze and smoke.
MBA-1715 Semi-Covert Infrared Filter (715nm):
This filter has a sharp cut-on at 715nm and
passes the greatest amount of infrared energy of all of the Maxa Beam filters. When this filter is
attached, a red glow is visible to the naked eye. It is useful for nature studies, extreme long range
surveillance and search applications where total covertness is not required. It is compatible with
Gen. 2 & 3 night vision equipment and IR sensitive cameras. With this filter attached, the Maxa
Beam has an effective range of up to 2,500m.
MBA-1850 Covert Infrared Filter (850nm):
This filter has a sharp cut-on at 850nm and better
than 90% pass efficiency above 850nm. A red glow can only be seen if the light is boresighted and
observed against a dark background at close range. It is useful for surveillance and search
applications where background lights (such as those in urban areas) will mask its glow. It is
compatible with Gen. 2 & 3 night vision equipment and IR sensitive cameras. With this filter
attached, the Maxa Beam has an effective range of up to 1,200m.
MBA-1900 Fully Covert Infrared Filter (900nm):
This filter has a sharp cut-on at 900nm. It is
compatible with IR sensitive cameras and is virtually undetectable to the naked eye. With this filter
attached, the Maxa Beam has an effective range of up to 500m.
MBA-1950 Fully Covert Infrared Filter (945m):
This filter has a sharp cut-on at 945nm. It is
compatible with IR sensitive cameras and is virtually undetectable to the naked eye and most night
vision equipment. With this filter attached, the Maxa Beam has an effective range of up to 250m.
Summary of Contents for Maxa Beam 400 series
Page 15: ...15 ...
