4
Searchlight Operation
General Operation
Setup:
1)
Locate light, battery and power cable.
2)
Inspect items for physical damage.
3)
Attach searchlight to battery by lining up
round feet of searchlight over round holes
on the top of the battery (a). Lower the
searchlight into the holes and then slide the
searchlight towards the connector end of
the battery (b). Check for positive lock by
sliding searchlight away from connector
end of battery. If properly locked, it should
not slide.
4)
If desired, attach a battery shoulder strap to diagonally opposite ears on battery.
5)
Attach male end of power cable to connector on battery. These are keyed;
never force cable
connections.
To lock rotate only the locking ring clockwise.
6)
Attach female end of power cable to 4-pin male connector on searchlight. These are keyed;
never force cable connections.
To lock rotate only the locking ring clockwise.
To release searchlight from battery pack:
1)
Lift lock release lever under searchlight handle (located at the rear of handle).
2)
Slide searchlight forward, away from connector end of battery.
To turn searchlight on:
1)
Momentarily press the red power on/off switch
located on the handle at front. If the light does not
light in 5 seconds, press the red button again to stop
the starting process and see the troubleshooting
section of this manual.
2)
The searchlight will light at high beam and hold this
setting for 3 seconds. The intensity will then drop
to the programmed power setting.
To change the size of the searchlight’s beam:
1)
Rock the beam conditioning switch to the rear to widen beam. Rock the beam conditioning
to the front to narrow beam. When you reach the desired beam width, release switch.
a
b
Lock Release Lever
Lock Release Lever
Summary of Contents for Maxa Beam 400 series
Page 15: ...15 ...
