Document Number PD196-253R6
PDI-E24
” LED TV User Manual
Page 14 of 36
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
Channels
The Channel Setup menu allows you to program different signal sources
into three Service Levels (Free, Basic, and Premium) and to add or delete
individual channels. It also allows you to block channels, TV programs,
movies, and auxiliary sources that can be input to the TV. Each Service
Level contains a different channel map.
1. Press the SETUP button on the remote control.
2. Press
▲ or ▼ to highlight Channel Setup.
3. Press
► to enter the Channels sub-menu.
Signal
Four different tuning types are available depending upon the healthcare
facility
’s signal type. Selection of the correct signal type is required for the
TV to recognize all possible channels and before any channel
programming can begin.
NOTE:
Most hospitals use the Cable STD signal style.
1. Enter the Channel Setup menu
2. Press
▲ or ▼ to highlight Signal.
3. Press
◄ or ► to select Air, Cable STD, Cable IRC, or Cable
HRC.
4. Now perform Auto Program or Add/Delete Channels to adjust the
channels.
Auto Program
The TV scans each available channel for activity. Channels that display
activity are memorized into the selected Service Level.
NOTE:
A programmed service level can also be reprogrammed if
desired. Digital channel auto programming may take longer than 10
minutes to complete.
1. After setting Signal, press
▲ or ▼ to highlight Auto Program.
2. Press
► to select it.
3. On Mode, press
◄ or ► to select the scope of channel scanning.
Analog Only: TV searches for analog channels only.
Digital Only: TV searches for digital channels only.
Analog and Digital: TV searches for both analog and
digital channels.
4. Press
▲ or ▼ to highlight Channel Sequence.
5. Press
◄ or ► to select the Channel Sequence in which the
channels are displayed.
Interleave A+D: Channels are displayed in the order of channel number. ( Digital)
All A then D: All digital channels are displayed after all analog channels.
6. Press
▲ or ▼ to highlight Add’l Digital Signal.
7. Press
▲ or ▼ to select a signal type to scan for digital channels in addition to the signal type selected on
the previous menu.
None: Only the primary signal type will be scanned for digital channels
Air or Cable: This signal type will be scanned for digital channels after the primary type is
scanned.
