Document Number: PD196-244R12
PD295-002
Page 17 of 29
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
Menu 6
Menu 6 provides STB configuration settings and firmware information.
MENU ITEM
EXPLANATION
TV Input for STB
Sets the TV’s signal type input to correspond to the STB’s signal output. The
majority of
STB’s utilize modulated RF as the signal type and is the type shown in this instruction
manual. TUNER is the default setting. Additional settings are available for
STB’s with
different output signal types.
TV Chan for STB
When the STB Signal Input is set to “Tuner”,
this sets the channel the TV tunes to view
the STB’s signal. This setting should match the STB’s “CH” switch setting
(which is
usually 3 or 4) or the modulator channel number.
STB Model
Model number of set top box. Must match actual unit for proper operation.
NOTE: Changing the STB Model does not change the previous STB Key selections. If
the STB Model is changed, the STB Key selections should be reviewed to determine if
they are the desired mappings for the installation.
Restore Defaults for
STB
Press vol
►
to restore all interface settings, for the selected STB model, to factory
defaults.
NOTE: Each STB m
odel has a unique set of Factory Defaults. Selecting “Restore
Factory Defaults” changes the parameters to the Factory Defaults for the selected STB
model and does not c
hange the “STB Model” selection
.
The default settings for each supported STB are
detailed below in “Appendix B –
STB
Functions and Default Mapping Reference”
Flash Intface Pwr
LED
This provides a diagnostic tool to help determine if the TV is connected to the expected
Satellite Interface and
STB. If “Flash Intface Pwr LED” is turned on, the “POWER”
LED
on the Satellite Interface module controlled by this TV will flash rapidly. The STB
controlled by this interface will also turn on and off continuously.
NOTE: This is not a stored parameter. It is automatically
set to “OFF” by cycling power to
the interface module.
Power Save
If “Power Save” is turned ON, the STB wil
l be automatically powered off when the TV is
turned off
Interface F/W Ver
PDi set top box Interface firmware version
TV CCI Ver
CCI communication protocol version reported by TV
IR Cable
Connection status of IR Emitter cable to the interface module.
INTERFACE MODULE SETUP 6/6
TV Input For STB
Tuner
TV Chan For STB
003
STB Model
DC50X
Restore Defaults for STB
>
Flash Intface Pwr LED
Off
Power Save
On
DIAGNOSTICS
IR Interface F/W Ver
V4.02
TV CCI Ver
V5.2
IR Cable
Connected
Exit: SETUP/OK Cancel: POWER
