Document Number: PD196-244R12
PD295-002
Page 21 of 29
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
Restoring Factory Default Settings
The Interface Module configuration can be reset to factory defaults. Resetting to defaults cannot be undone. If the
Interface is connected to a PDI-
P19W the default configuration will be optimized for the P19W’s keypad. It will not match
the settings that came preloaded onto the Interface.
1. Enter the Interface Module Setup Menu (See
“Understanding
Interface
Module Setup Menus
”
earlier in this manual).
2.
Select menu “
Interface Module
SETUP 6/6”.
3.
Highlight the “Restore Factory Defaults” item.
4.
Press “VOL►” to restore factory defa
ults. The operation will happen
immediately and cannot be undone.
Operation
PDI Interface Module
operation is straight forward once configured. Site installations that involve a secondary “Off Air”
signal require additional instruction to provide a worry-free patient viewing experience.
Cable/Satellite TV Operation
1. Turn the TV on. A channel from the set top box should be displayed.
2. Channel the TV Up or Down. The set top box channel should follow.
3. Press the designated Guide button
or press “00”
. A channel guide should appear.
4. Select a channel from the Guide. The viewed set top box channel should follow the selection.
Off-Air TV Operation (Optional)
1. a. If using the TV Tuner for cable/satellite programming, press the control button designated for STB Power (see
section
“Programming for Off
-Air Non-Satellite Channels Using OFF-AIR RF Pass-
Thru”).
b. If using an input other than RF Tuner for cable/satellite programming, press the TV/AV key repeatedly until the
TV Tuner source is selected.
2. The STB signal should disappear.
3. Channel the TV Up or Down. The TV should now tune the Off-Air channels (non-STB channels).
4. a. If using the TV Tuner for cable/satellite programming, press the control button designated for STB Power
again.
b. If using an input other than RF Tuner for cable/satellite programming, press the TV/AV key again until the
cable/satellite box source is selected.
5. The Off-Air channel should disappear and be replaced with a cable/satellite channel.
6.
Press the TV’s power button to turn off the TV at any time.
INTERFACE MODULE SETUP 6/6
TV Input For STB
Tuner
TV Chan For STB
003
STB Model
DC50X
Restore Defaults for STB
>
Flash Interface Pwr LED
Off
Power Save
On
DIAGNOSTICS
IR Interface F/W Ver
V4.02
TV CCI Ver
V4.6
IR Cable
Connected
Exit: SETUP/OK Cancel: POWER
