MODEL:
PDi BELLA-HD Interface
Document Number:
PD196-426R1
User Manual
Page 6 of 27
PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪
www.PDiarm.com
and
www.mymedTV.com
▪ Phone 800.628.9870
ATX / Pico Digital MPC-12
Blonder Tongue MIRC-12V with MIPS-12C
Drake
®
RMM-12 with PSM121
Holland HMR with HMPS
When it is more desirable to have the set-top-box and interface module located near the TV, the module may be used in a stand-alone
configuration without the need for a mini-mod chassis. In this case the PDi PD106-747 power adapter (not included) should be used
to power the interface module. Since the interface module uses very little energy, it has no special ventilation requirements. A
DirectTV set-top-box can power the mini-mod in place of the rack mount chassis power supply.
Connections
The PD295-004 BELLA interface module connects to the TV via standard CAT6a cable. CAT6a provides a higher bandwidth needed for
the HDMI video signal and the length should not exceed 250 feet. BELLA must be powered via the rack mounted chassis, a standalone
power adapter, or via a USB power connection. The IR Emitter cable must also be connected to the module and adhered to the IR
window of the corresponding set-top-box. CAT6a, HDMI and power cables are not provided with the Bella.
Wall Mounted Televisions
Wall Mounted TV – Data, Power, and IR Emitter Cable Installation
1. Connect 26 pin connector of cable PD106-981 to the TV’s 26 pin connector and the other end to the CCI connector on the BELLA
CCI port as shown below.
2. Connect an HMDI cable between the BELLA interface box and the TV.
3. Connect the CAT6a cable to the RJ45 port on the PD295-004 interface module.
4. Remove adhesive backer from the module and secure it to the rear of the TV.
5. For rack mounted interface module, connect rack minimod power cable to PD295-004. For stand-alone mounting, connect power
cord PD106-747 to PD295-004.
