MODEL:
PDi BELLA-HD Interface
Document Number:
PD196-426R1
User Manual
Page 20 of 27
PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪
www.PDiarm.com
and
www.mymedTV.com
▪ Phone 800.628.9870
Programming the STB Signal Input Type
The Interface Module must be programmed so that it knows which TV
source input needs the keys to be mapped to the STB. When any other
signal source is selected, all keys will operate normally.
1.
Enter the Interface Module Setup Menu (see “Understanding
Interface Module Setup Menus” earlier in this manual)
2.
Select menu “Interface Module SETUP 6/6”.
3.
Set “STB Signal Input” to match the connection to the STB.
This is usually Tuner but may be “HDMI” or “Component” for
high-definition STB’s.
4.
If “STB Signal Input” is “Tuner” then set the “STB Channel” to
match the STB’s modulated RF output. The illustration depicts
the channel as number 3 in this example.
5.
Exit setup. Verify the STB signal is now displayed on the television.
Restoring Factory Default Settings
The Interface Module configuration can be reset to factory defaults. Resetting to defaults
cannot be undone. If the Interface is connected to a PDI-P19W the default configuration will
be optimized for the P19W’s keypad. It will not match the settings that came preloaded onto
the Interface.
1.
Enter the Interface Module Setup Menu (See “Understanding Interface Module
Setup Menus” earlier in this manual).
2.
Select menu “Interface Module SETUP 6/6”.
3.
Highlight the “Restore Factory Defaults” item.
4.
Press “VOL►” to restore factory defaults. The operation will happen immediately
and cannot be undone.
Operation
PDi Interface Module operation is straight forward once configured. Site installations that involve a secondary “Off Air” signal require
additional instruction to provide a worry-free patient viewing experience.
Cable/Satellite TV Operation
1.
Turn the TV on. A channel from the set-top-box should be displayed.
2.
Channel the TV Up or Down. The set-top-box channel should follow.
3.
Press the designated Guide button or press “00”. A channel guide should appear.
4.
Select a channel from the Guide. The viewed set-top-box channel should follow the selection.
INTERFACE MODULE SETUP
TV Input For STB
Tuner
TV Chan For STB
003
STB Model
DC50X
Restore Defaults for STB
>
Flash Intface Pwr LED
Off
Power Save
On
DIAGNOSTICS
IR Interface F/W Ver
V5.00
TV CCI Ver
V4.6
IR Cable
Connected
Return: SETUP/OK/LAST
INTERFACE MODULE SETUP 6/6
TV Input For STB
Tuner
TV Chan For STB
003
STB Model
DC50X
Restore Defaults for STB
>
Flash Interface Pwr LED
Off
Power Save
On
DIAGNOSTICS
IR Interface F/W Ver
V5.00
TV CCI Ver
V4.6
IR Cable
Connected
Return: SETUP/OK/LAST
