MODEL:
PDi BELLA-HD Interface
Document Number:
PD196-426R1
User Manual
Page 17 of 27
PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪
www.PDiarm.com
and
www.mymedTV.com
▪ Phone 800.628.9870
Menu 6
Menu 6 provides STB configuration settings and firmware information.
MENU ITEM
EXPLANATION
TV Input for STB
Sets the TV’s signal type input to correspond to the STB’s signal output. The majority of STB’s utilize
modulated RF as the signal type and is the type shown in this instruction manual. TUNER is the default
setting. Additional settings are available for STB’s with different output signal types.
TV Chan for STB
When the STB Signal Input is set to “Tuner”, this sets the channel the TV tunes to view the STB’s signal.
This setting should match the STB’s “CH” switch setting (which is usually 3 or 4) or the modulator
channel number.
STB Model
Model number of set-top-box. Must match actual unit for proper operation.
NOTE: Changing the STB Model does not change the previous STB Key selections. If the STB Model is
changed, the STB Key selections should be reviewed to determine if they are the desired mappings for
the installation.
Restore Defaults for
STB
Press vol► to restore all interface settings, for the selected STB model, to factory defaults.
NOTE: Each STB model has a unique set of Factory Defaults. Selecting “Restore Factory Defaults”
changes the parameters to the Factory Defaults for the selected STB model and does not change the
“STB Model” selection.
The default settings for each supported STB are detailed below in “Appendix B – STB Functions and
Default Mapping Reference”
Flash Intface Pwr LED
This provides a diagnostic tool to help determine if the TV is connected to the expected Satellite
Interface and STB. If “Flash Intface Pwr LED” is turned on, the “POWER” LED on the Satellite Interface
module controlled by this TV will flash rapidly. The STB controlled by this interface will also turn on
and off continuously.
NOTE: This is not a stored parameter. It is automatically set to “OFF” by cycling power to the interface
module.
Power Save
If “Power Save” is turned ON, the STB will be automatically powered off when the TV is turned off
Interface F/W Ver
PDi set-top-box Interface firmware version
TV CCI Ver
CCI communication protocol version reported by TV
IR Cable
Connection status of IR Emitter cable to the interface module.
Programming the Interface Module
Programming the IR Code Set
The Interface Module sends infrared (IR) codes that mimic the set-top-box’s remote
control. Therefore the interface must know which set-top-box is being controlled to send
the proper codes.
1.
Enter the Interface Module Setup Menu (See “Understanding Interface Module Setup
Menus” earlier in this manual).
2.
Select menu Interface Module SETUP 6/6”.
3.
Set “STB Model” to match the actual model of the STB.
4.
Perform a factory reset (See Restoring Factory Default Settings later in this manual).
INTERFACE MODULE SETUP
TV Input For STB
Tuner
Restore Defaults for STB
>
Flash Intface Pwr LED
Off
Power Save
On
DIAGNOSTICS
IR Interface F/W Ver
V5.00
TV CCI Ver
V5.2
IR Cable
Connected
Return: SETUP/OK/LAST
