MODEL:
PDi BELLA-HD Interface
Document Number:
PD196-426R1
User Manual
Page 12 of 27
PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪
www.PDiarm.com
and
www.mymedTV.com
▪ Phone 800.628.9870
TV Setup – Most PDi TVs
To establish communications to the interface module, the CCI port on the TV
must be active and you must have a PDi programming remote PD108-420 (not
included). Follow the steps below:
1.
Press SETUP to enter the TV’s setup menu.
2.
From the setup menu select “Features”.
3.
If the “Standby Power” setting shows in this menu, change it to
“Normal”. Some TV’s do not have this setting so this step can be
ignored. Other TV’s may operate the interface module on any “Standby
Power” setting. This can be determined by trying it or contacting PDi.
4.
From the initial setup menu, select “Channels”.
5.
Change the “Pro:idiom” option to “MTI Port” or “Data Port”. Some TV’s
do not have this setting. In that case, this step can be ignored.
6.
From the initial setup menu, select “Sources”. Set each item as detailed
below.
The TV Source Setup must properly reflect the actual connections to
the TV. Incorrect settings will result in loss of programming or the
addition of blank signal sources. In most installations, both
cable/satellite and off-air programming is delivered over RF so the “TV
Tuner” must be enabled. If the cable/satellite channels are delivered
over an alternate method such as HDMI, then that source must be
enabled. All unused sources should be disabled.
