18
INTEGRATION GUIDE
5. The RM-WIFI-AC-2X2-HP-US radio module has been certified with the
antennas listed in the table above. For use as a client device (DFS non-master),
the integrator can choose or specify a different antenna of like type and equal
or lesser gain as an antenna appearing in the above table and still maintain
compliance. Reference FCC Part 15.204(c)(4) for further information on this
topic. Note that the highest antenna gain used for approval is 7 dBi.
6.
Important Note:
For use in a host system that is a DFS master, the minimum,
net antenna gain allowed is 1.1 dBi, including all other cable loss. Any antenna/
cable combination whose gain is lower than 1.1 dBi, including all other cable
loss, is not approved for use with a DFS master device without additional
testing and approval. Note that the highest antenna gain used for approval is
7 dBi.
7. The transmitter module has been evaluated for RF exposure on its own and
therefore should not be co-located with any other transmitter or antenna
without further testing and approval.
8. If deployed in the USA, any end-product using the RM-WIFI-AC-2X2-HP-US
radio module must be visibly labeled with the following:
Contains FCC ID: NYPRMWIFIAC2X2
9. The integrator or host manufacturer must not provide information to the end
user regarding the installation or removal of this modular transmitter from the
host device in the user’s manual of the end-product.
10. Any end-user manual shall include all required regulatory information/warnings
as shown in this manual.
11. Even though the PCTEL RM-WIFI-AC-2X2-HP-US radio module has been
FCC certified, the host product (i.e., the integrated product of radio
host device) needs to be evaluated for continued compliance in that specific
configuration. Contact PCTEL for any tools that may be required for such an
evaluation.
12. If any of these conditions cannot be met (for example by using a unique
antenna type), then the FCC certification is no longer considered valid, and the
FCC ID cannot be used on the host/final product. In these circumstances, the
integrator of the module is responsible for the re-evaluation of the end-product
(including the transmitter) and obtaining a separate FCC certification.
6.2. Manufacturer’s Innovation, Science and Economic Development (ISED)
Canada Compliance Statements
Model:
RM-WIFI-AC-2X2-HP-CA
IC ID:
26854-RMWIFIAC2X2
Manufacturer:
PCTEL, Inc.
471 Brighton Dr.
Bloomingdale, IL 60108-3102 USA
