PINO 3.0 E Building Instruction August 2018
www.pcm.at
5
Then, set the servo to the
zero position
and
screw it to the
frame
. The screwing is important, because if you screw the servo
after gluing it into the wing, tension will occur and the surface of
the wing will get wavy.
The
lever lengths:
Aileron: 8mm
(first hole of
the smaller lever of the KST
servos.)
Flaps: 10mm
(first hole of
the stronger lever of the KST
servos.)
The length is measured from
rotation center to hole center.
Flap servo:
Set the
servo
to its
zero position
and let the
lever
show a little bit
to the front
. So you get more break deflection.
Aileron servo
:
Let the lever in
rectangular
position.
Verify the
free movement
of all the parts.
It will be necessary, that you
optimize
the
lever
connector
as shown in the
pictures besides.
It has to be done in different
ways for the flaps and for the
ailerons.
Aileron servo
Flap servo
