4.07 Adjust settling time
If it is necessary to adjust the settling time, this can be done while doing this
Turn on the device
Press and hold the button until the current settling time appears on the
display
is
shown. ("Πb0" ~ "Πb6"). Πb0 is the slowest Πb6 the fastest value.
By pressing the
Button confirm the set value.
4.08 Adjust division
Press the
Key and keep it pressed while switching on the balance until
the current division is shown in the display. Now press the
Key around the value
adjust. By pressing the
Button confirm the set value.
4.09 Adjust backlight
Press the
1
Key and keep it pressed while switching on the balance until
the balance has completed the self-test. The current setting now appears on the display.
"AUTO" - the backlight is switched on and off automatically.
"A"
- Backlight is always on.
"OUT"
- Backlight is always off.
Now press the button to set the value. Press the button to confirm the set value.
4.10 Adapt data output (RS232)
Press the 2 key and keep it pressed while switching on the scale until the scale has completed the
self-
test. The current setting of the “Baud
Rate". Choose between 2400, 4800 and 9600 by pressing the
Button. By pressing
of the
Key to confirm the value. You can then choose between "ST" and "Co".
"ST" (stable) means that the data is only sent when the value on the scale has stabilized.
"Co" (continue) causes the data to be sent permanently via the interface.
By pressing the
Key to confirm the value.
- 6 -
