© PCE Instruments
27
Starting the RAMP
To enable Ramp, select Source Type as RAMP.
If this mode is enabled,
(Rising Ramp) or
(Falling Ramp) or
(Ramp Hold @
100%) or
(Ramp Hold @ 0%) icon will appear in Source Display Window according to
current RAMP mode in RUN Page and F1 and F2 Button change to
START
and
SETTING
respectively.
RAMP can be started by Pressing
F1
key (START). After that F1 and F2 key will change to
PAUSE
and
STOP
respectively. So by pressing F1 and F2 key running RAMP can be PAUSE or
STOP at any time in RUN Page.
4.4
DISPLAY Page
This Page appears when you select
RUN
→
MENU
→
DISPLAY.
There is mainly Four RUN Display Mode possible in this device. And this mode can be selected
from the above Page. What information to be shown in each RUN Display Mode can be defined
by this page.
In this page there is one RadioButtonBox. At a time one or two option can be selected. The
possible combinations are given below.
1
Measure Only
2
Source Only
3
M Source
4
Switch Test + Source
Summary of Contents for PCE-LOC 20
Page 38: ...PCE Instruments 36...
