© PCE Instruments
4
5
Preparation
Inserting the batteries (see also chapter 9)
•
Insert batteries into the battery compartment by first loosening the screw (3-10) and
removing the battery compartment cover (3-9).
•
Insert the 6 x AAA batteries into the compartment. Pay attention to the correct polarity.
•
Place the battery cover back on and secure it with the screw.
The display (3-1) now shows the relative humidity, temperature and CO2 content. The data
are measured by the sensor (3-6).
Note:
In chapter 8.6, you can see how to change the temperature unit (°C and °F).
6
Data logger
6.1
Preparation
a.
Insert the SD card (1 GB to 16 GB) into the SD card slot (3-13). Ensure that the
card is oriented correctly.
b.
When you use the card for the first time, it must be formatted. Refer to chapter 8.1
for more information.
Note:
Please do not use an SD card formatted in another device (e. g digital
camera) In this case, you have to format the SD card again in the data logger. If
there are any problems during formatting, please try to format the card in your PC.
This procedure may solve the problem.
c.
Set the time: When you use the meter for the first time, the time must be set. See
chapter 8.2 for more information.
d.
Format of decimal point: The format on the SD card uses a "dot" as the decimal
point, e
. g. “20.6” or “1000.53”. You can also choose a comma as decimal point,
see chapter 8.5.
e.
Information that can appear on the display:
This indicates a problem with the SD card. It is also displayed
when the SD memory card is full. In this case, replace the
memory card.
This indicates that the battery voltage is too low. In this case,
please replace the batteries.
This indicates that there is no memory card in the device.
