PCE Health and Fitness PCE-HT 224E, Operation Manual

Page: 13 / 29

3.2.2. Test zone setup
There are four parameters for test zone: test angle, pouring surface, carburized depth and
strength curve.
3.2.2.1. Setting test angle
On the parameter interface of new test zone, use upward and downward buttons to select
test angle, and then press Enter button to set test angle. There are a total of 9 angles
available. Press
and to select, then press to save and return to the parameter
interface of test zone.
3.2.2.2. Setting poured surfaces
On the parameter interface of new test zone, use upward and downward buttons to select
pouring surface, and click Enter button to set pouring surface. There are a total of 3 surfaces
available (Top surface, Bottom surface and Side surface). Press
and to select, then
press to save and return to the parameter interface of test zone.
3.2.2.3. Setting carburized depth
In the parameter setting interface of test part, use upward and downward buttons to select
the carburized depth, and then press Enter button to set carburized depth. Press
and
to adjust carburized depth from 0.0-6.0 (13 alternatives, 0.0mm, 0.5mm, 1.0mm,
1.5mm, 2.0mm, 2.5mm, 3.0mm, 3.5mm, 4.0mm, 4.5mm, 5.0mm, 5.5mm and 6.0mm).